Mounts to the transmission shifter bracket.
Learn More
Installation Notes
Installation Difficulty:
Level 2 Intermediate
Installation Time: Less than an hour
Parts Included
1 Transmissi...
If you are looking to swap out you axle shafts or ring and pinion of your Dana 30 or Dana 44 front axle, don't forget to replace the oil slinger seals. Fits front left or right inner axle shaft sli...
Factory replacement transfer case shift lever bushing for Jeep vehicles from Crown Automotive.
Learn More
Fits 97-06 Wrangler TJ with NP231 or NV241OR Transfer Case
Fits 87-95 Wrangler YJ with...
We just made the hardest to find fluid the easiest. This is the only replacement fluid for the Quadra-Trac transfer case and Crown Automotive has it!.
Learn More
The use of any other fluid in the...
When its time to change out your front hub assembly because of a bad bearing, it is nice to have fresh hardware during installation. The Crown Automotive Front Knuckle to Hub Bolt is the perfect re...
Fits Dana 30 Front Axle for the following: 76-86 CJ Series, 87-95 Wrangler YJ, 97-06 Wrangler TJ, 84-01 Cherokee XJ & 93-98 Grand Cherokee ZJ
Fits Dana 44 Front Axle for the following: 74-91 S...
For use with 5 bolt hold hub flange (not included).
Learn More
Installation Notes
Installation Difficulty:
Level 2 Intermediate
Installation Time: Less than an hour
Parts Included
Flan...
Front Drive Shaft to Transfer Case Bolt (12 Point).
Learn More
Installation Notes
Installation Difficulty:
Level 2 Intermediate
Installation Time: Less than an hour
Parts Included
1 Driv...
Learn More
Installation Notes
Installation Difficulty:
Level 2 Intermediate
Installation Time: Less than an hour
Parts Included
Single Gasket
Warranty
12 Month/12,000 Mile Limited...
Rugged Durability: Constructed to handle tough conditions, this axle shaft seal provides superior protection against leaks and contaminants for your Jeep Wrangler JK.
High-Quality Materials: Built ...
An essential part for 1985-1998 Jeep vehicles with NP207, NP/NV242, NP/NV231 or NP/NV249 Transfer Cases. Covered by 12 Month or 12 Mile Warranty.
Learn More
Installation Notes
Installation Di...
When you are looking to repair your drive shaft u-joints or worse case, you lost a u-joint in travel, it is good to have a couple Crown Automotive Yoke Strap & Bolt Kits handy. If it has been a...
For use with 6 bolt hold hub flange (not included).
Learn More
Installation Notes
Installation Difficulty:
Level 2 Intermediate
Installation Time: Less than an hour
Parts Included
Flan...
Learn More
Installation Notes
Installation Difficulty:
Level 4 Experts Only
Installation Time: 4-6 hours
Parts Included
3:55 Ratio Ring & Pinion Set
Warranty
12 Month/12,000 M...
The Crown Automotive Clutch and Brake Pedal Pad restores your firm pedal grip when shifting or braking in your Jeep. Over time the original pad will get worn down until if finally falls off and you...
