Learn More
Parts Included
Differential Case
Differential Gear Set
2 Differential Bearings
Warranty
12 Month, 12,000 Mile Limited Warranty.
Specs
Axle Model: Dana 44
Axle Position: R...
The Crown Automotive Output Shaft Oil Seal is for Jeeps with an NP231 transfer case that has been converted with a Crown Slip Yoke Eliminator (SYE) Kit. This is a replacement for the seal located i...
Learn More
Installation Notes
Installation Difficulty:
Level 1 Beginner
Installation Time: Less than an hour
Parts Included
1 Gasket
Warranty
12 Month/12,000 Mile Warranty
Specs...
Learn More
For the Following Automatic Transmission Applications:
1997-2002 TJ Wrangler with 30RH or 32RH Transmission
1987-1995 YJ Wrangler with A999 or 32RH Transmission
1984-1986 XJ Cherokee ...
Front outer wheel bearing for '76-'86 CJ with 1-5/8" inner diameter.
This does not include the Cup.
Learn More
For the Following Wheel Applications :
1963-1973 SJ, J-Series (Front Wheel Beari...
Learn More
Installation Notes
Installation Difficulty:
Level 2 Intermediate
Installation Time: Less than an hour
Parts Included
1 Front Hub Bolt
Warranty
12 Month/12,000 Mile Limi...
The Crown Automotive Output Oil Seal is for the Jeep CJ transfer cases. Dana Spicer models 18 and 20 use a lot of the same parts due to their similarity. This oil seal can be used at the front or r...
Precision Engineering: Manufactured to meet or exceed OEM specifications, ensuring smooth operation, minimal noise, and exceptional durability.
Direct-Fit Installation: Designed for a perfect fit o...
Direct Fit Replacement: Engineered to match the original axle shaft assembly for seamless installation and compatibility with your Jeep's existing drivetrain.
Durable Construction: Manufactured usi...
Made in the USA!
Learn More
Installation Notes
Installation Difficulty:
Level 2 Intermediate
Installation Time: 1-2 hours
Parts Included
1 Oil Seal
Warranty
12 month / 12,000 Mile L...
The Rust Buster Rear Coil Spring Bucket for the Wrangler JK is a direct replacement for OE. These spring buckets are made from 1/8" cold-rolled steel and weld to the frame, accepting OE springs and...
Learn More
M24x2.00 Nut Attaches Front Axle Shafts to Hub Assembly
Installation Notes
Installation Difficulty:
Level 2 Intermediate
Installation Time: Less than an hour
Parts Included...
